Trong quá trình chuẩn bị bê tông, mineral admixtures are necessary mixed materials to improve the performance of concrete. Commonly used mineral admixtures include tro bay, bột xỉ, vân vân., but in high-strength concrete, silica fume is also a must. Hỗn hợp khoáng, fly ash and silica fume are admixtures containing a large amount of silica, is it possible to replace fly ash with silica fume? Tiếp theo, I will tell you whether silica fume can replace fly ash through the comparison between silica fume and fly ash.
Performance comparison between silica fume and fly ash
Liquidity comparison
(1) Natural mobility
Put a steel pipe with a height of 18cm and a diameter of 7cm on a flat plastic paper, and slowly lift the steel pipe after it is freely filled with silica fume, and measure the free fall fluidity of the silica fume. The diameter is 20cm, and the center height is 7cm; use the same device And method, measured fly ash free fall fluidity diameter is 28cm, center height is 3.5cm. It can be seen that the diameter of the free flow of silica fume is 8cm smaller than that of fly ash, and the height of the center is 3.5cm. The natural flow of silica fume is smaller than that of fly ash.
(2) Slurry fluidity
Experiments were carried out on the fluidity of silica fume and fly ash cement (according to the determination method of fluidity of cement slurry), and the fluidity of cement slurry mixed with 3% và 5% silica fume was measured to be 220mm and 210mm respectively; The fluidity of cement paste with 3% và 5% fly ash is 220mm and 220mm respectively. It can be seen that the fluidity of the cement slurry mixed with 3% silica fume is the same as that of the cement slurry mixed with 3% tro bay, and the fluidity of the cement slurry mixed with 5% silica fume is lower than that of the cement slurry mixed with 5% tro bay. Spend.
Comparison of cement performance under the same proportion
- Adding silica fume in the same proportion requires less water than the standard consistency of fly ash, but with the increase of silica fume content, the water consumption of standard consistency increases.
- The initial setting time and final setting time of fly ash mixed with the same proportion are prolonged, and the setting time is further prolonged with the increase of silica fume content.
- With the addition of silica fume in the same proportion, the 3d and 28d compressive strengths of fly ash both increase, but with the increase of silica fume content, the increase rate of cement strength shows a downward trend.
Read More About Silica Fume and Fly Ash Visit: https://hsamaterial.com/blog/silica-fume-vs-fly-ash.html
Feasibility of silica fume replacing fly ash in the same proportion
After testing, it is found that when the same proportion of silica fume is used instead of fly ash, the fluidity loss of concrete increases, and the workability of construction becomes poor. Tuy nhiên, since silica fume fills the voids of concrete, the amount of mixing water decreases, and the strength of concrete at 7d and 28d Both increased, indicating that silica fume can improve the strength of concrete by replacing fly ash.
Since the initial setting and final setting time will be prolonged after the addition of silica fume, it is not suitable for preparation and use in seasons with low temperatures, and the silica fume is finer and has a smaller bulk density. Kho, feeding stability and admixture should be considered when using it. According to the test data, the appropriate dosage of silica fume as an admixture is 3%, which can reduce water demand and improve early and late strength.
Tóm lại, under certain conditions, khói silica can be added to cement or concrete instead of fly ash, nhưng trong thực tế sử dụng, the actual amount of silica fume added should be determined through a reasonable ratio test, and most In some cases, in order to improve the performance of concrete in many engineering projects, khói silica, fly ash and other admixtures are used in combination.
Micro silica fume from Henan Superior Abrasives Co., Ltd
With more than 20 năm sản xuất micro silica fume, Công ty mài mòn cao cấp Hà Nam, Ltd thể hiện mình là nhà cung cấp được đề nghị của bạn. Chúng tôi cung cấp các sản phẩm silica hiệu suất cao từ Trung Quốc. Your requirement for densified and undentified silica fume can be fulfilled in different configurations. Chia sẻ nhu cầu dự án của bạn, và chúng tôi sẽ cung cấp cho bạn yêu cầu tùy chỉnh của bạn. Các nhà máy của chúng tôi ở Trung Quốc có thể cung cấp các cấu hình khói silic khác nhau theo yêu cầu.
Nhận khói silica của bạn được cung cấp trong túi dệt bằng nhựa 1000kg tùy chỉnh và 10kg và 20 kg túi giấy hòa tan. Túi dệt bằng nhựa cũng có sẵn với số lượng cung cấp nhỏ. Các vật liệu tiêu chuẩn cao của chúng tôi được sử dụng trong các dự án khác nhau trên khắp thế giới. Chúng tôi luôn cam kết cung cấp những vật liệu tốt nhất với dịch vụ nhanh chóng.
